Nudge Bar Install Instructions | |
|
|
Nudge Bar Instructions. | |
76mm ECB Nudge Bar Install: | |
1. Remove
14mm head bolt from sway bar bracket (located just behind bumper bar
bolts). 2. Remove spot welded nut from chassis (use chisel and hammer or similar). 3. Attach steel mounting bracket (supplied) to chassis. Use 3/8 x 1 ¼ bolt and nut (supplied) for where nut was removed and 3/8 x 1 ½ bolt and nut for tie down hole in chassis. Note: Fit Alloy washer plate to bolt and insert bolt from the inside of chassis. 4. Tighten mounting bracket in position. Note: Tighten 3/8 x 1 ¼ bolt and nut first. 5. Repeat for other side. 6. Attach ECB nudge Bar to inside of steel mounting bracket. Use 3/8 x 1 ¼ bolts and nuts (supplied) DO NOT TIGHTEN! 7. Align ECB nudge bar so that when viewed from the side the front of the nudge bar is vertical. 8. Tighten All Bolts Here are some pics:
Fitting Kit: 2- Steel Mounts. |
|
HOME | |
Last updated on 04/24/2001 12:47 AM |